Drawing Arcs

Procedure

1. Open the property for which you need to create a sketch.
2. Open the property's Improvement panel.
3. Open the improvement and click Details.
4. In the Improvement dialog box, click Sketches.
5. Draw a sketch.
6. Use one of the following methods:
   • When using the keyboard, before you click the end point of an exterior wall, use your scroll wheel to arc the line as required. After the arc is set, click the end point.
   • Use the Pointer to select the center point of a line. Either drag the center point, or type the height of the arc and press the required arrow key. See the example sketch below.
   • On an existing line, right click at the point to begin the arc and select Wall > Split Here. Then use the Pointer to select the center point of the new line segment and drag it as required. See the example sketch below.

     

7. Save the sketch.

Top of Page Print

Copyright © Harris Govern